21 December,16 at 11:14 PM
Applies to: DirectControl 5.3.0 and above on all supported platforms
Problem:
During debugging of cloud connectors the following parameter is used: adclient.cloud.connector in centrifydc.conf. During testing of mfa authentication the adclient will use the configured connector, however 'adinfo -y cloud' will show a different connector.
Cause:
This is a code issue, upon running 'adinfo -y cloud' the utility will find an available cloud connector rather than use the configured cloud connector in centrifydc.conf. In turn this could cause the utility's results to display the wrong connector.
Resolution:
This is fixed in 2017.