Centrify

Tips for finding Knowledge Articles

  • - Enter just a few key words related to your question or problem
  • - Add Key words to refine your search as necessary
  • - Do not use punctuation
  • - Search is not case sensitive
  • - Avoid non-descriptive filler words like "how", "the", "what", etc.
  • - If you do not find what you are looking for the first time,reduce the number of key words you enter and try searching again.
  • - Minimum supported Internet Explorer version is IE9
Home  >
article

KB-5961: How to enable Smart Card login on RHEL 7

Authentication Service ,  

12 April,16 at 11:44 AM

Applies to: 
   
All versions of Centrify DirectControl on Red Hat 7.0 & 7.1 
   
   
Question: 
   
What are the steps to enable Smart Card login on RHEL 7.0 or 7.1? The latest Smart Card Guide for Linux released with Suite 2015.1 does not mention this OS version explicitly. 
   
   
Answer: 
   
To enable Smart Card login on a Red Hat 7.0 or 7.1 system please follow the appropriate steps as outlined in the Linux Smart Card Configuration guide. Although the guide does not cite RHEL 7.x specifically the steps in this document have been tested and verified by Centrify. If you need technical assistance after following the prescribed steps please contact Centrify Support for assistance. 

https://www.centrify.com/downloads/products/documentation/suite2015/centrify-linux-smartcard.pdf 

(All links are provided as a courtesy)

Related Articles

 articleKB-7442: Smart Card type supported by Centrify Access Manager articleKB-27501: Citrix VDA smart card pass-through to Centrify on RHEL articleKB-7555: Unable to login as root after upgrade to Centrify Suite 2016 (CDC 5.3.0) articleKB-3415: How to enable Smart Card logon support on RedHat environments articleKB-7415: Unable to unlock screen with Smart Card on RHEL 7.3 and lower articleKB-6041: How to show current license type in use by adclient article[HOWTO] to set up smart card authentication for PAS portal login articleKB-10294: Cannot unlock screen with Smart Card after successful login on RHEL 7.4 and higher articleKB-6040: How to change the license type in use after adclient successful joined to the AD?